|
|
这次联检(joint review), 足足被问了近4小时,不过几乎都是技术方面的,幸好准备充分。虽然很累,感觉还不错。因为ASME Designee 提问的目的并不是刁难,而是他要检查我是否真的unerstood the code。例如code 要求对接管(nozzle)内口作min. 3mm 的圆角,有下面问答:
can you and how do you check this 3mm radius?
it's tough for really check since this radius usually is hand made.
what's the purpose you placed this value?
conform to the code book requirement , reduce pressure loss.
you know its difficult to check, do you think this is practical?
not practical but the 'bibble' book required. can you provide me advice to overcome this issue, thks!
remove the detailed value of 3mm, just write dwon" the inside corner of nozzle neck wall should be rounded".
thks a lot, i will do it.
|
评分1
-
查看全部评分
|
|