ASTM A1015 Info

mechen

ASTM Identifier	ASTM A1005/A1005M 00(2010)
Revision Number	2000 R10 EDITION
Title	Standard Specification for Steel Line Pipe, Black, Plain End,  Longitudinal and Helical Seam, Double Submerged-Arc Welded
Status	Current
Modification Type	Reapproval
Publication Date	April 1, 2010, midnight
Document Type	Specification
Page Count	6
Scope	1.1  This specification covers double submerged-arc welded, black, plain end steel  pipe for use in the conveyance of fluids under pressure. Pipe in sizes NPS 16  and larger, as given in ASME B36.10, are included; pipe having other dimensions,  in this size range, are permitted, provided such pipe complies with all other  requirements of this specification.    1.2  It is intended that pipe be capable of being welded in the field when welding  procedures in accordance with the requirements of the applicable pipeline  construction code are used.    1.3  The values stated in either inch-pound units or in SI units are to be  regarded separately as standard. The values in each system are not exact  equivalents, therefore, each system is to be used independently of the other,  without combining values in any way.    1.4 The following  precautionary statement pertains to the test method portion, Section 14 of  this specification: This standard does not purport to address all of the safety  concerns, if any, associated with its use. It is the responsibility of the  user of this standard to establish appropriate safety and health practices  and determine the applicability of regulatory limitations prior to use.
Keywords	black steel pipe; double submerged-arc welded; line pipe; Double  submerged-arc welded pipe--specifications; Black steel pipe--specifications;  Helical-seam double submerged-arc welded pipe; Longitudinally welded pipe;  Welded steel pipe--specifications; ICS Number Code 77.140.75 (Steel pipes and  tubes for specific use); 23.040.10 (Iron and steel pipes)
Abstract	This specification covers  double submerged-arc welded, black, plain end steel pipes for use in the  conveyance of fluids under pressure. The pipes shall be capable of being  welded in the field. Skelp widths for helical seam pipe shall be neither less  than 0.8 nor more than 3.0 times the pipe's specified outside diameter. Skelp  end welds shall not be permitted in finished pipe, except for helical seam  pipe having its skelp end welds manufactured by double submerged-arc welding.  For such pipes, skelp ends shall have been properly prepared for welding. The  specimens shall undergo the following tests: tension test, guided bend test,  Charpy V-notch test, and hydrostatic test. After hydrostatic test,  nondestructive examinations by ultrasonic inspection shall be done.
Committee Number	A01.09
To find similar documents by ASTM Volume:	01.01 (Steel--Piping, Tubing, Fittings)
To find similar documents by classification:	23.040.10 (Iron and steel pipes)   77.140.75 (Steel pipes and tubes for specific use)

liuyu1029

-
沙发，谢分享，顶楼主
     

阿谢克那·李

顶起mechen，顶顶！

stevendong

楼主威武，加油加油

a22g22k22

感謝分享，吧手上資料更新更新。