|
|
发表于 2018-7-5 15:33:50
|
显示全部楼层
ASME BPVC SECTION II MATERIALS Part A
Ferrous Material Specifications(Beginning to SA-450)
SA-20/SA-20M SPECIFICATION FOR GENERAL REQUIREMENTS FOR
STEEL PLATES FOR PRESSURE VESSELS
Page 74
14. Permissible Variations in Dimensions or Mass
14.1 One cubic foot of rolled steel shall be assumed to
weigh 490 lb, unless otherwise stated in the applicable product
specification. One cubic metre of rolled steel is assumed to
have a mass of 7850 kg, unless otherwise stated in the
applicable product specification.
14.2 For carbon steel plates the permissible variations for
dimensions shall not exceed the applicable limits stated in
Annex A1, Table A1.1 to Table A1.9, and Table A1.13 [Annex
A2, Table A2.1 to Table A2.9, and Table A2.13].
14.3 For alloy steel plates the permissible variations for
dimensions shall not exceed the applicable limits stated in
Annex 1, Table A1.1 to Table A1.4, Table A1.8, and Table
A1.10 to Table A1.13. [Annex 2, Table A2.1 to Table A2.4,
Table A2.8 and Table A2.10 to Table A2.13].
14.4 Conversions of Permitted Variations from Fractions of
an Inch to Decimals—Permitted variations in dimensions for
products covered by this specification are generally given as
fractions of inch and these remain the official permitted
variations, where so stated. If the material is to be measured by
equipment reporting dimensions as decimals, conversion of
permitted variations from fractions of an inch to decimals shall
be made to three decimal places; using the rounding method
prescribed in Practice E29. |
|
|