|
|
发表于 2016-2-26 23:45:26
|
显示全部楼层
本帖最后由 lyklzy 于 2016-2-26 23:49 编辑
沙发说的是正解。一般来说短路过渡容易出熔合不良(与母材,焊道间),而且不易被 RT 检出。
ASME BPVC. IX-2015
QW-304 WELDERS
Except for the special requirements of QW-380, each welder who welds under the rules of the Code shall have passed the mechanical and visual examinations prescribed in QW-302.1 and QW-302.4 respectively. Alternatively, welders may be qualified by volumetric NDE per QW-191 when making a groove weld using SMAW, SAW, GTAW, PAW, and GMAW (except short‐circuiting mode for radiographic examination)也不让用 RT 评定GMAW短路过渡焊工。
执行 Semi-automatic GMAW 的是 WELDER,所以 GMAW 短路过渡的焊接方法不让用的原因就是因为半自动。
焊工用 Semi-automatic GMAW 方法焊出来的焊接接头质量不稳定,工厂经常用的检测方法又是 RT ,一般的 UT 也没有记录,所以干脆就不让用 Semi-automatic GMAW 了。
|
|
|