|
|
QW-160 GUIDED - BEND TESTS 导弯试验
Specimens of base metal thickness equal to or greater than 1-1/2 in. (38 mm) may be cut into approximately equal strips
between 3/4 in. (19 mm) and 1-1/2 in. (38 mm) wide for testing, or the specimens may be bent at full width (see require-
ments on jig width in QW-466). When the width of the weld is so large that a bend specimen cannot be bent so that the en-
tire weld and heat affected zones are within the bent portion, multiple specimens across the entire weld and heat affected
zones shall be used.
请问这里的第一句wide for testing是否应该是thickness for testing
|
|
|