PEvlite异径管接头如何建模计算

zdp0120

在PEvlite异径管接头如何建模计算，请各位指点指点！

KR2012

UG-44 FLANGES AND PIPE FITTINGS
The following standards covering flanges and pipe fit-tings are acceptable for use under this Division in accor-dance with the requirements of UG-11. Pressure–temperature ratings shall be in accordance with the ap-propriate standard except that the pressure–temperature ratings for ASME B16.9 and ASME B16.11 fittings shall be calculated as for straight seamless pipe in accordance with the rules of this Division including the maximum al-lowable stress for the material。
标准的大小头按照直管计算即可。

asme19

感谢楼主分享的资料

zdp0120

KR2012 发表于 2019-5-12 09:40
UG-44 FLANGES AND PIPE FITTINGS
The following standards covering flanges and pipe fit-tings are acc ...

这个大小头还是偏心的，也是按照直管计算么